m menu image  m home m cart

Polar False Clamp Pin, 206035, P10

$11.00

Add to Cart:



  • Our Part Number: P10

False clamp pin for use on Polar guillotine paper cutters. (Equivalent to Polar part number 206035) 47mm (1.85") long. These are notched for the latch pin, as shown in the photo.  These pins are used in all Polar cutters built before approximately 1985.

For installation, the underside of the original pin must be drilled or ground off, then the pin can be knocked out with a hammer and punch.  After inserting the new pin, the bottom end of these pins gets hammered or peened over to install them in your Polar false clamp.

Made in the USA.

See our part number P11 for false clamp pins used after approximately 1985.